Warning: Parametric solver does not support geometry and mesh dependent parameters

Dear all,

I want to sweep a parameter, but the geometry and mesh depend on the parameter. Then I get the warning message

Parametric solver does not support geometry and mesh dependent parameters.

I found a related discussion thread, where Ivar replied

-------------------------------------------------------------------------
Hi
In which context did you get that error, if you have selected a Solver Continuation parametrical sweep then it is because that is NOT looping over the geoemtry and the mesh.

To perform a parametric sweep to change the geoemtry and to remesh you need to add a separate "parametric Sweep" node before your solver node

--
Good luck
Ivar
-------------------------------------------------------------------------

Does anyone know how to add the separate "parametric sweep" node?

Thanks!