Usually the circular inductor can be simplified as a 2D axisymmetric model in COMSOL, which means much less elements, DOF and memory cost.
However, if we want to simulate a square inductor, does it means we can only use the 3D model?
I build a 3D model, and add the Single Turn Coil Domain feature to this, but it seems to be hard to get a convergence.
Is there some tips which shall be noticed when model a non-circular section closed loop with the "Gap feed" Single Turn Coil Domain feature?
Wish to receive some feedbacks!
However, if we want to simulate a square inductor, does it means we can only use the 3D model?
I build a 3D model, and add the Single Turn Coil Domain feature to this, but it seems to be hard to get a convergence.
Is there some tips which shall be noticed when model a non-circular section closed loop with the "Gap feed" Single Turn Coil Domain feature?
Wish to receive some feedbacks!