Hi there,
I have two issues:
1. I am unable to save my model. I have imported an assembly from solidworks into comsol and when I try to save I get the error " An invalid XML character (Unicode 0x4) was found in the element content: t(s("//geom/geoms[key='geom1']/value/feature/features[key='cad1']/value)) m(s("set")) s("param") sa(s..."
( for the complete message see the attached screenshot.
2. I have created a cross-section of the 3-d image I have imported, and I was trying to compute my physics but i get a meshing error, about intersecting faces. I can generate the mesh by clicking 'build all' in the mesh section of the model., but not compute the solution.
Finally, I was wondering if there were any suggestions to the model. I am trying to model an Magnetic induction tomography system (hence the coils around the pipe).
Thank you
Mukund
I have two issues:
1. I am unable to save my model. I have imported an assembly from solidworks into comsol and when I try to save I get the error " An invalid XML character (Unicode 0x4) was found in the element content: t(s("//geom/geoms[key='geom1']/value/feature/features[key='cad1']/value)) m(s("set")) s("param") sa(s..."
( for the complete message see the attached screenshot.
2. I have created a cross-section of the 3-d image I have imported, and I was trying to compute my physics but i get a meshing error, about intersecting faces. I can generate the mesh by clicking 'build all' in the mesh section of the model., but not compute the solution.
Finally, I was wondering if there were any suggestions to the model. I am trying to model an Magnetic induction tomography system (hence the coils around the pipe).
Thank you
Mukund