Hi All,
I have been having some issues meshing a cylinder. When you define a cylinder in COMSOL, it splits the curved face into 4 quarters, and as a result, when I went to mesh the cylinder I was irregularities at these 4 points, where the mesh is clearly trying to conform to these 4 lines.
I would like to know how to solve this problem, so that my mesh is uniform around the length of this curved face. I have tried to get COMSOL to ignore the four edges, and I have also had it make a single composite face from the four individual ones. In both cases, when it came to meshing, the mesh acted like these lines were still there.
Any ideas?
B
I have been having some issues meshing a cylinder. When you define a cylinder in COMSOL, it splits the curved face into 4 quarters, and as a result, when I went to mesh the cylinder I was irregularities at these 4 points, where the mesh is clearly trying to conform to these 4 lines.
I would like to know how to solve this problem, so that my mesh is uniform around the length of this curved face. I have tried to get COMSOL to ignore the four edges, and I have also had it make a single composite face from the four individual ones. In both cases, when it came to meshing, the mesh acted like these lines were still there.
Any ideas?
B