Hi everyone,
I created a geometry whose dimensions are related to a few parameters which I have been defining under "Global Definitions > Parameters".
Now I would like to change some of these parameters (let's say two, but even one would be ok), run the simulation and store the results for different values of the parameters. Is there a wayto do so automatically, or am I supposed to change the values manually?
For instance, let's say I have a clamped beam with an applied load at the free end.
The beam has a square section (side "A") and its lenght is "L".
I want to know its maximum deformation (or whatever) for each combination of A and L in a certain range.
For exemple:
L = [1,2,3]
A =[0.1,0.2,0.3]
Is there the possibility to do so?
Thank you very much
I created a geometry whose dimensions are related to a few parameters which I have been defining under "Global Definitions > Parameters".
Now I would like to change some of these parameters (let's say two, but even one would be ok), run the simulation and store the results for different values of the parameters. Is there a wayto do so automatically, or am I supposed to change the values manually?
For instance, let's say I have a clamped beam with an applied load at the free end.
The beam has a square section (side "A") and its lenght is "L".
I want to know its maximum deformation (or whatever) for each combination of A and L in a certain range.
For exemple:
L = [1,2,3]
A =[0.1,0.2,0.3]
Is there the possibility to do so?
Thank you very much