Hello everyone, relatively new to COMSOL here, I am trying to create a model
describing a simulation that took place in a climate chamber. I have attached a
graph describing the temperature on the water container surface. I want help modeling
that step-up near the 1600s mark, how should I "make the water warmer" before it starts
cooling again? I have looked into the continuous casting model for guidance and I have
used some methods described in it but I am stuck...
The physics I use is heat transfer in solids and the custom water I have
has a Cp = 4200 - (2120*(T<T_freeze)) +exp(-(T-T_freeze)^2/((dT)^2))/sqrt(pi*(dT)^2)*333000
where dT=1[K] and T_freeze = 0[degC]
Any help would be welcome!
Thank you!
describing a simulation that took place in a climate chamber. I have attached a
graph describing the temperature on the water container surface. I want help modeling
that step-up near the 1600s mark, how should I "make the water warmer" before it starts
cooling again? I have looked into the continuous casting model for guidance and I have
used some methods described in it but I am stuck...
The physics I use is heat transfer in solids and the custom water I have
has a Cp = 4200 - (2120*(T<T_freeze)) +exp(-(T-T_freeze)^2/((dT)^2))/sqrt(pi*(dT)^2)*333000
where dT=1[K] and T_freeze = 0[degC]
Any help would be welcome!
Thank you!