Hi everyone,
I'm running a simulation on a micro cantilever coated with a film. My goal is to observe the deformation and stress distribution on the cantilever, under the application of temperature differential and compressive boundary load on the film.
I have the results, but I need to generate a 2D plot of the stress values vs. the width of the cantilever, to see how it varies about 3 microns from the fixed end. I'm using Comsol 4.3. How can I go about doing this ?
I'm running a simulation on a micro cantilever coated with a film. My goal is to observe the deformation and stress distribution on the cantilever, under the application of temperature differential and compressive boundary load on the film.
I have the results, but I need to generate a 2D plot of the stress values vs. the width of the cantilever, to see how it varies about 3 microns from the fixed end. I'm using Comsol 4.3. How can I go about doing this ?