Hi ,
I'm facing a problem with FSI module . for the model in micro fluids library ( obstacle in fluid ) the dimensions are in microns ,
when increase the dimensions in Cm ( only scaling the model ) , the message " nonlinear solver did not converge " appear .
So is there any settings that can overcome this problem??
thanks alot
I'm facing a problem with FSI module . for the model in micro fluids library ( obstacle in fluid ) the dimensions are in microns ,
when increase the dimensions in Cm ( only scaling the model ) , the message " nonlinear solver did not converge " appear .
So is there any settings that can overcome this problem??
thanks alot