HOw do I combine the particle tracing and rotating machinery modules so that they can run simultaneously in a study? I am attempting to study the particle trajectories in a 3-D mixer (the same mixer design that is used in COMSOL's "Baffled Mixer" model).
When I run a study using both the rotating machinery and particle tracing modules, I will get a message that says Failed to find consistent initial values.
Last time step is not converged..
I never get convergence when I run the teo modules at the same time, but I get convergence no problem if I run either of the modules by itself. Is there a setting I would have to change?
When I run a study using both the rotating machinery and particle tracing modules, I will get a message that says Failed to find consistent initial values.
Last time step is not converged..
I never get convergence when I run the teo modules at the same time, but I get convergence no problem if I run either of the modules by itself. Is there a setting I would have to change?