Hi to all!
I'm getting some trouble about induction heating using frequency-transient solver.
In the 2D-axisymmetric model, I have an aluminium workpiece surrounded by 12 turn of coil (each one setted in "single turn coil domain 1").
In the "single turn coil domain 1" I set the power of the coil, and here is the problem! If i set very low power (10-60 W) the simulation works so good, but if I set the power I need (at least 6000 W) I get the error
"Time-Dependent Solver 1 (sol1/t1)
Failed to find consistent initial values"
I think I have to change some BC, but i don't know which one!
Anyone knows?
Thank you!
I'm getting some trouble about induction heating using frequency-transient solver.
In the 2D-axisymmetric model, I have an aluminium workpiece surrounded by 12 turn of coil (each one setted in "single turn coil domain 1").
In the "single turn coil domain 1" I set the power of the coil, and here is the problem! If i set very low power (10-60 W) the simulation works so good, but if I set the power I need (at least 6000 W) I get the error
"Time-Dependent Solver 1 (sol1/t1)
Failed to find consistent initial values"
I think I have to change some BC, but i don't know which one!
Anyone knows?
Thank you!