Hello!
I managed to get comsol to run in batch mode (Linux). However, after I open my newly created output model file out.mph, I do not see any graphs available. I am solely interested in CFD module, where comsol usually builds Velocity and Pressure plots if run with GUI. I want to have access to those after I open out.mph with Comsol GUI again.
I tried to run my computation command with -graphics switch, but nothing changed.
Is there a way to get those plots, with animation and all that stuff?
If not, where are the output files and how to interpret them? Any computation is useless unless you can access some sort of output.
Any help is greatly appreciated!
I managed to get comsol to run in batch mode (Linux). However, after I open my newly created output model file out.mph, I do not see any graphs available. I am solely interested in CFD module, where comsol usually builds Velocity and Pressure plots if run with GUI. I want to have access to those after I open out.mph with Comsol GUI again.
I tried to run my computation command with -graphics switch, but nothing changed.
Is there a way to get those plots, with animation and all that stuff?
If not, where are the output files and how to interpret them? Any computation is useless unless you can access some sort of output.
Any help is greatly appreciated!