Hi,
I have been trying to sweep mesh a domain (3-D). It will be like a small straight tube of rectangular cross section and having turns at right angles (like a serpentine). I tried to mesh the source and destination faces using 'edge' and 'mapped' option and subsequently tried to sweep mesh the entire domain. All I can get is, "invalid topology at the vertex". I found a pdf (lnf.umich.edu/nnin-at-michigan...loads/2012/11/comsol-guide.pdf), in which a domain similar to mine has been sweep meshed in page number 356 using comsol 3.5a. I am not able to find options like that in comsol 4.2, which I am using.
I kindly ask the experts in this area to comment on this and advice me. Thanks in advance.
I have been trying to sweep mesh a domain (3-D). It will be like a small straight tube of rectangular cross section and having turns at right angles (like a serpentine). I tried to mesh the source and destination faces using 'edge' and 'mapped' option and subsequently tried to sweep mesh the entire domain. All I can get is, "invalid topology at the vertex". I found a pdf (lnf.umich.edu/nnin-at-michigan...loads/2012/11/comsol-guide.pdf), in which a domain similar to mine has been sweep meshed in page number 356 using comsol 3.5a. I am not able to find options like that in comsol 4.2, which I am using.
I kindly ask the experts in this area to comment on this and advice me. Thanks in advance.