Hey guys, I have a 2'' hollow tube that is fixed at one end and has a point load at the other end. (think cantilever)
What I need is this:
I need the radius of curvature to be 3'', so I need to know what force to apply to the end of the tube. How would I go about doing this? Please note that currently I am using a 2'' piece of tube, but the length may vary. Not sure if it matters or not.
Any help is appreciated thanks.
What I need is this:
I need the radius of curvature to be 3'', so I need to know what force to apply to the end of the tube. How would I go about doing this? Please note that currently I am using a 2'' piece of tube, but the length may vary. Not sure if it matters or not.
Any help is appreciated thanks.